LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1996 (Engine Controls And Fuel - 3.5L - DTC P025A/P0300 To DTC P0700) >> DTC P025A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the FPCM.
  2. Ignition OFF, connect a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, command the fuel pump ON and OFF with a scan tool ECM fuel pump output control. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals