Conditions for Running the DTC

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The following conditions must be met prior to ignition OFF.

DTCs P0112, P0113, P0116, P0117, P0118, P0120, P0125, P0128, P0443, P0446, P0449, P0452, P0453, P0463, P0503, P1106, P1107, P1111, P1112, P1114, P1115, P1516, P2101, P2108, P2120, P2125, P2129, P2138, P2610 are not set.
The diagnostic runs once after a cold start drive cycle.
The start-up intake air temperature (IAT) is between 4-30°C (39-86°F).
The start-up engine coolant temperature (ECT) is less than 30°C (86°F).
The start-up IAT and ECT are within 8°C (15°F).
The barometric pressure (BARO) is greater than 74 kPa.
The ambient air temperature is between 2-32°C (36-90°F).
The engine run time minimum is 10 minutes.
The vehicle has traveled greater than 5 kilometers (3 miles) this trip.
The ECT is greater than 70°C (158°F).
The fuel level is between 15-85 percent.
The ignition is OFF.
A refueling event is not detected.
DTC P0442 runs once per drive cycle during the hot soak period after the ignition is turned OFF and may require up to 45 minutes to complete. The ECM will not make more than 2 tests per day.