Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, remove the line pressure test hole plug and install the J 21867 to the transmission.
- Perform the Line Pressure Check
. Verify the transmission line pressure gage is within the range specified in the Line PC Solenoid Valve Pressure table. Refer to Solenoid Valve Pressure
.
- If not within the specified range, repair as necessary. Refer to Fluid Pressure High or Low for further diagnosis.
- Ignition OFF, remove the control solenoid (w/body and TCM) valve assembly.
- Install the DT-47825 to the control solenoid (w/body and TCM) valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test for detailed instructions.
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
. A pressure change should occur.
- If a pressure change does not occur, replace the control solenoid (w/body and TCM) valve assembly.
- Inspect for the following conditions and repair/replace as necessary:
- The control valve upper body assembly for sticking valves, damage, scored bores, or debris
- The clutch select valve 3 for damage