Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, remove the control solenoid (w/body and TCM) valve assembly.
- Install the DT-47825 to the control solenoid (w/body and TCM) valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test for detailed instructions.
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
. A pressure change should occur.
- If a pressure change does not occur, replace the control solenoid (w/body and TCM) valve assembly.
- Inspect for the following conditions and repair/replace as necessary:
- Converter feed limit valve in the control valve lower body for a stuck valve, debris or damage
- TCC control valve and the TCC regulator valve in the control valve upper body for a stuck valve, debris or damage
- Torque converter assembly for damage or discoloration