Circuit/System Verification (Hybrid)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Engine running for at least 1 minute.
- Ignition OFF for 30 seconds to allow complete shutdown of the TCM.
- Ignition ON, verify that DTC P0602 is not set.
- If the DTC is set, program the TCM. If the DTC resets, replace the TCM.
- Observe the DTC information with a scan tool. DTC P0601, P0603, P0604, and P062F should not set.
- If a DTC sets, replace the TCM.
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.