LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1991 (Engine Controls And Fuel - 3.6L (LCS) - DTC P0192 To DTC P0629) >> DTC P0601-P0604, P0606, P0607, P062B, P0167D, P2107, or P2610 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function.
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
    • If the hood position does not display Open, refer to DTC P254F .
  3. Ignition ON, observe the DTC information with a scan tool. Verify that DTC P0562 is not set.
  4. Ignition ON, observe the DTC information with a scan tool. DTC P0602 or P0606 should not set.
    • If DTC P0602 failed this ignition, program the ECM. If the DTC resets, replace the ECM.
    • If DTC P0606 failed this ignition, clear the DTCs with a scan tool and verify the DTC does not reset. If DTC resets, replace the ECM.
  5. Observe the DTC information with a scan tool. DTC P0601, P0603, P0604, P0607, P062B, P167D or P2610 should not set.
    • If a DTC failed this ignition, replace the ECM.
  6. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals