Conditions for Running the DTC
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
P0153
- DTCs P0036, P0054, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0151, P0152, P0154, P0155, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The HO2S Bank 2 Sensor 1 Heater command parameter is ON for greater than 40 seconds.
- The ECT sensor parameter is greater than 65°C (149°F).
- The Intake Air Temperature (IAT) Sensor parameter is greater than -40°C (-40°F).
- The Engine Run Time parameter is greater than 60 seconds.
- The vehicle is not in Park, Reverse, or Neutral.
- The Loop Status parameter is closed.
- The mass air flow (MAF) sensor parameter is between 17-37 g/s.
- The TP Indicated Angle parameter is greater than 3.5 percent.
- The Engine Speed parameter is between 1,250-2,550 RPM.
- The evaporative emission (EVAP) system is purging.
- The Barometric (BARO) parameter is at least 69.8 kPa.
- The above conditions have been met for 3 seconds.
P0154
- DTCs P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The Engine Run time parameter is greater than 2 minutes.
P0160 - Fast Pass Test
- DTCs P0056, P0060, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0141, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2135, P2176 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The Engine Run Time parameter is less than 90 seconds.
P0160 - Regular Test
- DTCs P0056, P0060, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0141, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The Fast Pass Test has failed.
- The Engine Run Time parameter is greater than 124 seconds.
- The TP Indicated Angle parameter has changed more than 3 percent at least 1 time.
- The Loop Status parameter is closed.
P1153
- DTCs P0050, P0059, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0151, P0152, P0154, P0155, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0451, P0452, P0454, P0455, P0496, P1516, P2101, P2119, P2135, P2176, P2A03 are not set.
- The system voltage is between 10-18 volts.
- The scan tool special functions are not active.
- The HO2S Bank 2 Sensor 1 Heater command parameter is ON for greater than 40 seconds.
- The ECT Sensor parameter is greater than 65°C (149°F).
- The IAT Sensor parameter is greater than -40°C (-40°F).
- The Engine Run Time parameter is greater than 60 seconds.
- The EVAP purge solenoid is commanded ON.
- The MAF sensor parameter is between 17-37 g/s.
- The Engine Speed parameter is between 1,250-2,550 RPM.
- The TP Indicated Angle parameter is greater than 3.5 percent.
- The Loop Status parameter is closed.
- The BARO parameter is at least 69.8 kPa.
- The Fuel Level parameter is greater than 10 percent.
- The vehicle is not in Park, Reverse, or Neutral.
- The above conditions have been met for 3 seconds.
P2272
- DTCs P0050, P0059, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0151, P0152, P0153, P0154, P0155, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0453, P0454, P0455, P0496, P1153, P1516, P2101, P2119, P2135, P2176, P2273, P2A03 are not set.
- The system voltage is between 10-18V.
- The Fuel Level parameter is greater than 10 percent.
- Engine run time is more than 60 seconds.
- The engine speed is between 1,250-1,750 RPM.
- Airflow is equal to or more than 3 g/s and equal to or less than 12 g/s.
- The vehicle speed is equal to or more than 70 km/h (43.5 mph) and equal to or less than 120 km/h (74.6 mph).
- The short term fuel trim is between 0.84-1.06.
- The fuel state is in Closed Loop.
- The HO2S heater ON time is greater than 180 seconds.
- The Decel Fuel Cut-Off (DFCO) parameter is active.
- This DTC runs once per trip when all of the above conditions have been met for 1 second.
P2273
- DTCs P0050, P0059, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0151, P0152, P0153, P0154, P0155, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0453, P0454, P0455, P0496, P1153, P1516, P2101, P2119, P2135, P2176, P2273, or P2A03 are not set.
- The system voltage is between 10-18V.
- The Fuel Level parameter is greater than 10 percent.
- Engine run time is more than 60 seconds.
- The DFCO parameter is active.
- The Accelerator Pedal Position (APP) Inducted Angle parameter is 0 percent.
- The Torque Converter Clutch (TCC) Duty cycle parameter is 100 percent.
- DTC P2272 has run and passed.
- This DTC runs once per trip.
P2A03
- DTCs P0050, P0059, P0068, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0151, P0152, P0153, P0154, P0155, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0496, P1133, P1153, P1516, P2101, P2119, P2135, P2176, P2A00 are not set.
- The Engine Run Time parameter is more than 100 seconds.
- The MAF Sensor parameter is between 5-30 g/s.
- The Engine Speed parameter is between 500-3,000 RPM.
- The ECT Sensor parameter is more than 65°C (149°F).
- The DFCO parameter is inactive.
- The Power Enrichment (PE) parameter is inactive.
- The Ignition 1 Signal parameter is between 10-18 volts.
- DTC P2A03 runs continuously when the above conditions are met for 5 seconds.