LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1988 (Engine Controls And Fuel - 2.4L - DTC P0010 To DTC P0315) >> DTC P0231, P0232, or P023F >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the fuel pump.
  2. Connect a test lamp between the control circuit terminal 1 and ground.
  3. Ignition ON, command the fuel pump ON and OFF using a scan tool ECM fuel pump output control. The test lamp should turn ON and OFF as commanded.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the FPCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the FPCM.
  4. Ignition OFF, connect a test lamp between the control circuit terminal 2 and the control circuit terminal 1.
  5. Ignition ON, command the fuel pump ON using a scan tool. The test lamp should illuminate.
    • If the test lamp does not illuminate, test the control circuit terminal 2 for a short to voltage or an open/high resistance. If the circuit tests normal, replace the FPCM.
  6. If all circuits test normal, replace the fuel tank fuel pump module.
scientia non olet · About LEMON Manuals