LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1987 (Engine Controls And Fuel - 3.6L (LCS) - DTC P0008 To DTC P0193) >> DTC P0121, P0122, P0123, P0221, P0222, or P0223 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function.
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
    • If the hood position does not display Open, refer to DTC P254F .
  3. Ignition OFF, remove the fuse that supplies B+ to terminal X2-56 of the ECM.
  4. Disconnect the harness connector at throttle body assembly.
    5. NOTE: The control module or the sensor may be damaged if the circuit is shorted to battery positive voltage.
  5. Test for less than 5 Ω between the low reference circuit terminal C and ground.
    • If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. Install fuse that supplies B+ to terminal X2-56 of the ECM.
  7. Ignition ON, test for 4.8-5.2 V between the 5-volt reference circuit terminal E and ground.
    • If less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  8. Ignition ON, verify that the scan tool TP sensor 1 voltage parameter is less than 0.3 V.
    • If greater than the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  9. Connect a 3 A fused jumper wire between the 5 volt reference circuit terminal E and the TP sensor 1 signal circuit terminal D. Verify the scan tool TP sensor 1 voltage parameter is greater than 4.89 V.
    • If less than the specified value, test the signal circuit for an open/high resistance or for a short to ground. If the circuit tests normal, replace the ECM.
  10. Verify the scan tool TP sensor 2 voltage parameter is greater than 4.97 V.
    • If less than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
    11. NOTE: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage.
  11. Connect a 3 A fused jumper wire between the TP sensor 2 signal circuit terminal F and ground. Verify the scan tool TP sensor 2 voltage parameter is less than 0.10 V.
    • If greater than the specified value, test the signal circuit for an open/high resistance or for a short to voltage. If the circuit tests normal, replace the ECM.
  12. If all circuits test normal, replace the throttle body assembly.
scientia non olet · About LEMON Manuals