LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1987 (Engine Controls And Fuel - 3.6L (LCS) - DTC P0008 To DTC P0193) >> DTC P0111-P0113 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function.
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
    • If the hood position does not display Open, refer to DTC P254F .
  3. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  4. Ignition ON, verify that the scan tool IAT sensor parameter is at -40°C (-40°F).
    • If greater than the specified value, test the signal circuit for a short to ground. If the circuit/connections test normal, replace the engine control module (ECM).
  5. Ignition OFF, remove the fuse that supplies B+ to circuit terminal X2-56 of the ECM.
    6. CAUTION: Do NOT use a test lamp to test the continuity of the circuit. Damage to the control module may occur due to excessive current draw.
  6. Test for less than 5 Ω between the low reference circuit terminal E and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance, or for a short to voltage. If the circuit/connections test normal, replace the ECM.
  7. Install the fuse that supplies B+ to circuit terminal X2-56 of the ECM.
    8. NOTE: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.
  8. Ignition ON, install a 3 A fused jumper wire between the signal circuit terminal D and ground. Verify the IAT sensor parameter is greater than 134°C (274°F).
    • If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit/connections test normal, replace the ECM.
  9. If all circuits/connections test normal, test or replace the MAF/IAT sensor.
scientia non olet · About LEMON Manuals