Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- With the engine at normal operating temperature, raise the engine speed to 2,000 RPM for 10 seconds. DTCs P0010, P0013, P0020, P0023, P2088, P2089, P2090, P2091, P2092, P2093, P2094, or P2095 should not set.
- Engine idling, observe the following scan tool control circuit status parameters:
- CMP Sol Ckt Short Gnd Test Status
- CMP Sol Ckt Open Test Status
- CMP Sol Ckt Short Volts Test Status
Each parameter should display OK or Not Run.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.