LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1982 (Hybrid Engine Electrical System 2.4L (Hp7)) >> Repair Instructions >> Battery Current Sensor Replacement (HP7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Current Sensor
    GM1822982Courtesy of GENERAL MOTORS CORP.
  1. Remove the battery negative cable. Refer to Battery Negative Cable Replacement (HP7) .
  2. Mark the location of the battery current sensor on the battery positive and negative cable with tape for reference during installation.
  3. Remove the tape securing the battery current sensor to the battery positive and negative cable.
  4. Mark the location of the battery positive and negative cable clips and remove the clips from the cable.
  5. Squeeze the battery positive and negative cable branches together.
    6. NOTE: Note the orientation of the battery current sensor prior to removal.
  6. Slide the battery current sensor (1) off of the battery positive and negative cable.
scientia non olet · About LEMON Manuals