LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1982 (Hybrid Engine Electrical System 2.4L (Hp7)) >> Repair Instructions >> Battery Current Sensor Replacement (HP7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Current Sensor
    GM1822982Courtesy of GENERAL MOTORS CORP.
  1. Squeeze the battery positive and negative cable branches together.
    2. NOTE: Ensure the battery current sensor is installed in the correct direction and location on the battery positive and negative cable.
  2. Slide the NEW battery current sensor (1) up onto the battery positive and negative cable to the location previously marked during removal.
  3. Wrap electrical tape around the battery current sensor leg in order to secure the sensor to battery positive and negative cable.
  4. Install the battery positive/negative cable clips to the locations previously marked during removal.
  5. Install the battery positive and negative cable. Refer to Battery Negative Cable Replacement (HP7) .
scientia non olet · About LEMON Manuals