LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1978 (Engine Controls And Fuel - 3.5L - Troubleshooting & Diagnosis) >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the Service Bay Test aborts or fails, a DTC will NOT be set.
  1. Install a scan tool.
  2. Select the Service Bay Test with the scan tool.
    3. WARNING: Refer to Road Test Warning .
  3. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test, then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  4. Verify that the EVAP inspection/maintenance system status is set to YES.
scientia non olet · About LEMON Manuals