LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1977 (Engine Controls And Fuel - 3.6L (Ly7) - Troubleshooting & Diagnosis) >> Poor Fuel Fill Quality

Poor Fuel Fill Quality

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Problem Causes
DEFINITION: During the fueling process a continual, occasional or no fuel nozzle shut-off condition has occurred.
Difficult to fill
  • Fuel fill limiter vent valve stuck closed
  • Evaporative emission (EVAP) canister restricted
  • EVAP vent valve stuck closed
  • Hose between canister and canister vent solenoid twisted or kinked if applicable
  • High fuel temperature
  • Fuel filler hose is kinked
  • Faulty dispensing nozzle
  • Ignition switch ON, vent valve closed
Over fill
  • Fill limiter vent valve stuck open or leaking
  • Fuel inlet check valve stuck open
Pre-mature shut-off of the fuel dispensing nozzle occurs immediately after engaging dispensing nozzle, tank empty
  • Restricted vapor lines or fuel fill pipe
  • High fuel temperature
  • Inlet check valve at tank stuck closed, fill pipe full of fuel
  • Fuel tank full, gage not accurate
Pre-mature shut-off of the fuel dispensing nozzle, more than 1/8 of tank capacity dispensed
  • Kinked, pinched or plugged lines in fuel tank vent system
  • EVAP vent valve stuck closed or restricted
  • EVAP canister restricted
  • Fuel limiting vent valve stuck closed or obstruction at top of fuel tank
Fuel Spitback
  • Restricted EVAP canister
  • High fuel temperature
  • Ignition switch ON, EVAP vent valve closed