Particulate Contaminants in Fuel Testing Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel.
- Place the container on a level surface for approximately 5 minutes in order to allow settling of the particulate contamination. Particulate contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as black and irregular particles.
- Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system.