LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1974 (Tire Pressure Monitoring System) >> Diagnostic Information and Procedures >> DTC C0750, C0755, C0760, or C0765 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the J-46079  , activate each tire pressure sensor and record each sensors transmission data and physical location. See Special Tools . Verify J-46079  displays the 8-digit ID number, accurate tire pressure ±27. See Special Tools .6 kPa (4 psi), Learn Mode, and at least a 1/4 graph signal strength displayed.
    • If any of the parameters listed above are not displayed, replace the suspect tire pressure sensor.
  2. With the scan tool, verify tire pressure sensors ID and locations displayed on the scan tool match the IDs and locations recorded from the special tool.
  3. Enable the TPM learn mode. Use the J-46079  in simulate mode to learn 4 simulated sensor transmissions into the RCDLR. See Special Tools . Verify that all 4 simulated sensor locations, IDs, and tire pressures displayed on the TPM special tool match the corresponding scan tool parameters displayed.
    • If the scan tool does not match, replace the RCDLR.
  4. Test drive the vehicle above 40 km/h (25 mph) for greater than 2 minutes. With the scan tool, observe the suspect Pressure Sensor Mode data parameter. Verify the sensor mode changes to Rolling.
    • If the Pressure Sensor Mode does not change, replace the suspect tire pressure sensor.
scientia non olet · About LEMON Manuals