LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1968 (Hybrid Controls - 2.4L (Hp7)) >> Diagnostic Information and Procedures >> DTC P1A9E or P1AA2 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the 3 phase cable connections at the SGCM. Refer to Generator Control Module Replacement .
  2. Verify that the 3 phase cables are torqued to within specifications. Refer to Fastener Tightening Specifications .
  3. With a scan tool, clear the DTC.
  4. Ignition OFF, wait 30 seconds.
  5. Ignition ON, operate the vehicle within the Conditions for Running the DTC.
    • If the DTC resets, replace the SGCM.
scientia non olet · About LEMON Manuals