LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1967 (Hybrid Energy Storage System - 2.4L (Hp7)) >> Repair Instructions >> Generator Battery Disconnect Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Generator Battery Control Module
    GM1998867Courtesy of GENERAL MOTORS CORP.
  1. Install the generator battery control module (2).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the generator battery control module bolts (1) and tighten to 8 N.m (71 lb in).
    3. Fig 2: Generator Battery Control Module Nut
    GM1998864Courtesy of GENERAL MOTORS CORP.
  3. Position the generator battery temperature sensor wiring harness and the battery cables to the generator control module.
  4. Connect the generator battery temperature sensor wiring harness electrical connectors (5, 6) to the generator control module.
  5. Install the battery cable (4), and the generator battery control module nut (3) to the stud and tighten the nut to 8 N.m (71 lb in).
  6. Install the battery cable (2), and the generator battery control module nut (1) to the stud and tighten the nut to 8 N.m (71 lb in).
    7. Fig 3: Locating Generator Battery Components
    GM1864889Courtesy of GENERAL MOTORS CORP.
  7. Install the 3 small wire terminal leads to the batteries.
  8. Install the generator battery cable leads (3, 4, 5) to the batteries.
  9. Install the generator battery cable nuts (2) and tighten to 8 N.m (71 lb in).
  10. Install the generator battery terminal covers (1).
    11. Fig 4: View Of Generator Battery Cover
    GM1831948Courtesy of GENERAL MOTORS CORP.
  11. Install the generator battery cover.
    12. Fig 5: Locating Generator Battery Cover Components
    GM1831947Courtesy of GENERAL MOTORS CORP.
  12. Install the 12 generator battery cover bolts (1) and tighten to 8 N.m (71 lb in).
  13. Install the 2 generator battery fan bolts (2) and tighten to 8 N.m (71 lb in).
  14. Install the generator battery wiring harness to the clip (3) on the generator battery cover.
  15. Install the generator battery carrier. Refer to Generator Battery Carrier Replacement .
  16. Connect the hybrid battery. Refer to Hybrid Battery Service Disconnect/Connect .
scientia non olet · About LEMON Manuals