Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission fluid auxiliary cooler outlet pipe (5) to the vehicle.
- Install the transmission fluid auxiliary cooler outlet pipe bolt (4) and tighten to 22 N.m (16 lb ft)
- Install the transmission fluid auxiliary cooler outlet pipe nut (3) and tighten to 22 N.m (16 lb ft)
- Install the transmission fluid auxiliary cooler inlet pipe (2).
- Install the transmission fluid auxiliary cooler inlet pipe bolt (1)and tighten to 22 N.m (16 lb ft).
- Install the transmission fluid auxiliary cooler outlet pipe (2) to the thermal bypass valve.
- Connect the transmission fluid auxiliary cooler outlet pipe quick connect fitting (1) at the thermal bypass valve. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection
- Install the drive motor generator power inverter module support. Refer to Generator Control Module Bracket Replacement .
Fig 1: Auxiliary Cooler Inlet Pipe, Bolt, Auxiliary Cooler Outlet Pipe Nut And Auxiliary Cooler Outlet Pipe Bolt
CAUTION:
Refer to Fastener Caution
.