LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1963 (Automatic Transmission - 2MT70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Auxiliary Cooler Inlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive motor generator power inverter module support. Refer to Generator Control Module Bracket Replacement .
    2. Fig 1: Outlet Pipe Quick Connect Fitting And Fluid Auxiliary Cooler Inlet Pipe
    GM2158343Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the transmission fluid auxiliary cooler outlet pipe quick connect fitting (1) at the thermal bypass valve. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection 
  3. Remove the transmission fluid auxiliary cooler inlet pipe (2) from the thermal bypass valve.
    4. Fig 2: Fluid Auxiliary Cooler Inlet Pipe Bolt And Fluid Auxiliary Cooler Inlet Pipe
    GM2158344Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission fluid auxiliary cooler inlet pipe bolt (1).
  5. Remove the transmission fluid auxiliary cooler inlet pipe (2) from the vehicle.
scientia non olet · About LEMON Manuals