LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1963 (Automatic Transmission - 2MT70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power inverter module. Refer to Drive Motor Generator Power Inverter Module Removal and Installation
    2. Fig 1: Range Select Cable
    GM2152488Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the range select cable (2) from the range select lever.
  3. Release the range select cable retaining clip (1) and remove the cable from the range select cable bracket.
    4. Fig 2: Range Select Lever Cable Bracket
    GM2152747Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (1) securing the range select lever cable bracket.
  5. Remove the range select lever cable bracket (2).
scientia non olet · About LEMON Manuals