LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1963 (Automatic Transmission - 2MT70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information And Procedures >> Whine/Growl Noise That Changes with Vehicle Speed

Whine/Growl Noise That Changes with Vehicle Speed

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Checks Causes
Input Shaft Thrust Bearing Assembly Inspect the bearing for wear or damage.
Sun Gear Carrier Thrust Bearing Assembly
  • Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
  • Inspect for a damaged center support roller bearing assembly.
  • Inspect for damaged thrust bearings.
  • Inspect for damaged sun gears.
  • Inspect the carrier assembly for damaged output carrier rear sun gear thrust bearing (captured).
  • Inspect for damaged or stripped splines on the output carrier assembly.
Internal Gear Thrust Bearing Assembly Inspect the bearing for wear or damage.
Front Differential Carrier Assembly Inspect for damaged gears and bearings.
Front Differential Drive Pinion (w/Transfer Gear) Gear Assembly Inspect for damaged gears and bearings.
Variable High 2-3-4 Clutch Hub Thrust Bearing Assembly Inspect the bearings for wear or damage.
Variable High 2-3-4 Clutch Housing Thrust Bearing Assembly Inspect the bearing for wear or damage.
Input Shaft Bushing Inspect the bushing for wear or damage.
1-3R Clutch Housing Bushing Inspect the bushing for wear or damage.
Internal Gear Thrust Washer - 2nd Position Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
Internal Gear Thrust Bearing Inspect the bearing for wear or damage.
Output Shaft Thrust Bearing Assembly Inspect the output carrier inner sun gear shaft bearing for damage or wear.
Variable High 2-3-4 Clutch Housing Thrust Bearing Assembly
  • Inspect for damaged or restricted fluid filter assembly.
  • Inspect for damaged fluid filter seal assembly or improper sealing interface (leaks, fluid aeration).
Internal Gear Thrust Washer - 2nd Position - Plastic Inspect the washer for wear or damage.