Back Flush
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the SA 9165T: line flusher to the oil cooler feed line. Use the DT-48312: flushing adapter.
- Clip the discharge hose (2) onto the oil drain container.
- Attach the SA 9165T: line flusher to the undercarriage of the vehicle with the hook provided and connect the flushing system feed supply hose (1) from the SA 9165T: line flusher to the oil cooler return line. Use the DT-48312: flushing adapter.
- Turn the SA 9165T: line flusher water supply valve (3) to the ON position and allow water to flow through the oil cooler and lines for 10 seconds to remove any remaining transmission fluid. If water does not flow through the oil cooler and lines, the cause of the blockage must be diagnosed and the plugged component must be repaired or replaced. Continue with the cooler flushing and flow check procedure once the blockage is corrected.
- Turn the SA 9165T: line flusher water supply valve (3) to the OFF position and clip the discharge hose onto a 19 liter (5 gallon) pail with a lid, to avoid splashback.
- Turn the SA 9165T: line flusher water supply valve (3) to the ON position and depress the trigger (1) to mix cooler flushing solution into the water flow. Use the clip provided on the handle to hold the trigger (1) down. The discharge will foam vigorously when the solution is introduced into the water stream.
- Flush the oil cooler and lines with water and solution for 2 minutes. During this flush, attach the shop air supply 550-700 kPa (80-100 psi) to the flushing system feed air valve (2) located on the SA 9165T: line flusher, for 3-5 seconds at the end of every 15-20 second interval to create a surging action.
- Release the trigger (1) and turn the SA 9165T: line flusher water supply valve (3) to the OFF position.
NOTE:
Inspect the transmission oil cooler lines for kinks or damage. Repair as necessary.
NOTE:
Flushing for approximately 2 minutes in each cooler line direction will result in a total of about 8-10 gallons of waste fluid. This mixture of water and flushing fluid is to be captured in a bucket or similar container.