Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Gasoline/Gasoline Vapors Warning .

Fig 1: View Of Quick-Connect Fitting Retainer (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Relieve the fuel system pressure. Refer to the Fuel Pressure Relief (with CH 48027-100) or Fuel Pressure Relief (w/o CH 48027-100) .
Remove the fuel feed line quick connect fitting retainer.

Fig 2: Blowing Dirt Out Of Fitting (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Safety Glasses Warning .

CAUTION: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution .

Blow dirt out of the fitting using compressed air.

Fig 3: View Of Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

Choose the correct tool from the J 37088-A for the size of the fitting. See Special Tools . Insert the tool into the female connector, then push inward in order to release the locking tabs.

Fig 4: View Of Quick Connect Locking Tabs (Metal Collar)

Courtesy of GENERAL MOTORS CORP.

WARNING: Refer to Relieving Fuel Pressure Warning .

Pull the connection apart.
Use a clean shop towel in order to wipe off the male pipe end.
Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.