LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1958 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Throttle Body
    GM1887829Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LY7) .
  2. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor (1).
    3. Fig 2: MAP Sensor Bolt And Sensor
    GM1887830Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor bolt (1) and sensor (2).
scientia non olet · About LEMON Manuals