LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1958 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Ignition Coil Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coils.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil bolts. Tighten the bolts to 10 N.m (89 lb in).
    3. Fig 2: Engine Wiring Harness Electrical Connectors
    GM1889242Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connectors (1) to the ignition coils.
  4. Install the injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LY7) .
scientia non olet · About LEMON Manuals