LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1958 (Engine Controls And Fuel - 3.6L (Ly7) - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Position Sensor Connectors
    GM1889265Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Disconnect the engine wiring harness electrical connector (3) from the bank 1 intake camshaft position (CMP) sensor (4).
    3. Fig 2: View Of Right CMP Sensor - Intake
    GM1285251Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals