LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1957 (Engine Controls And Fuel - 3.5L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump. Refer to Power Steering Pump Replacement (LZ4) .
    2. Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals