LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1956 (Engine Controls And Fuel - 2.4L - Introduction) >> Repair Instructions >> Fuel Tank Draining >> On The Ground

On The Ground

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Fuel supply lines will remain pressurized for long periods of time after the engine is shutdown. This pressure must be relieved before servicing the fuel system.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027-100)  or Fuel Pressure Relief (Without CH 48027-100) .
    2. WARNING: Whenever fuel line fittings are loosened or removed, wrap a shop cloth around the fitting and have an approved container available to collect any fuel.
  2. Disconnect the fuel feed quick connect fitting from the fuel rail. Refer Metal Collar Quick Connect Fitting Service .
  3. Install the 3/8 in. x 1/4 in fitting from the SA9127E-7  into the fuel feed quick connect fitting. See Special Tools .
  4. Connect a suitable drain hose to the other end of the adapter and connect the drain hose to a certified fuel handling cart.
  5. Connect a scan tool to the vehicle diagnostic connector and turn the ignition ON.
  6. Energize the fuel pump using the scan tool.
  7. Pump out the fuel until no more than 1/4 tank of fuel remains.
scientia non olet · About LEMON Manuals