LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1956 (Engine Controls And Fuel - 2.4L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
    3. Fig 1: Locating Exhaust CMP Sensor Connector
    GM1815153Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine wiring harness electrical connector (1) from the exhaust camshaft position (CMP) sensor.
    4. Fig 2: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
  4. Remove the exhaust CMP sensor bolt. (Intake CMP shown, exhaust CMP similar).
  5. Remove the exhaust CMP sensor.
scientia non olet · About LEMON Manuals