LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1956 (Engine Controls And Fuel - 2.4L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the exhaust CMP sensor for damage, replace as necessary.
  1. Lubricate the exhaust CMP sensor O-ring seal with clean engine oil.
  2. Install the exhaust CMP sensor. (Intake CMP shown, exhaust CMP similar).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the exhaust CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Locating Exhaust CMP Sensor Connector
    GM1815153Courtesy of GENERAL MOTORS CORP.
  4. Connect engine wiring harness electrical connector (1) to the exhaust CMP sensor.
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals