LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1955 (Wheel Drive Shafts) >> Repair Instructions >> Intermediate Shaft Replacement (LE5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intermediate Drive Shaft Bracket Mounting Bolts And Bracket
    GM1876159Courtesy of GENERAL MOTORS CORP.
  1. Position the intermediate drive shaft mounting bracket on the engine block.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the intermediate drive shaft mounting bracket bolts. Tighten the mounting bolts to 22 N.m (16 lb ft).
    3. Fig 2: Installing SA91112T On The Wheel Drive Shaft Oil Seal
    GM895295Courtesy of GENERAL MOTORS CORP.
  3. Install the J 44394-A  on the intermediate drive shaft. See Special Tools .
    4. Fig 3: Intermediate Drive Shaft And Mounting Bracket
    GM1876157Courtesy of GENERAL MOTORS CORP.
  4. Install the intermediate drive shaft.
  5. Remove the J 44394-A  from the intermediate drive shaft. See Special Tools .
    6. Fig 4: Intermediate Drive Shaft Mounting Bolts
    GM1876169Courtesy of GENERAL MOTORS CORP.
  6. Install the mounting bolts for the intermediate drive shaft.
  7. Install the intermediate drive shaft mounting bolts. Tighten the mounting bolts to 30 N.m (22 lb ft).
  8. Install a new O-ring for the intermediate drive shaft.
  9. Install a new retaining ring for the intermediate drive shaft.
  10. Install the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .
  11. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals