LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1953 (Antilock Brake System - Hybrid 2.4L (Hp7)) >> Repair Instructions >> Electronic Brake Control Module Replacement (HP7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EBCM
    GM1873923Courtesy of GENERAL MOTORS CORP.
  1. Install the EBCM seals, if removed.
  2. Install the EBCM (1) to the BPMV.
    3. Fig 2: EBCM Bolts
    GM1873922Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the 4 EBCM bolts (1) and tighten the bolts in a cross pattern and tighten to 3 N.m (27 lb in).
  4. Lower the vehicle.
  5. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  6. Install the battery. Refer to Battery Replacement .
  7. If installing a new EBCM, program the EBCM. Refer to Control Module References .
  8. Without starting the engine, place the ignition switch in the ON position.
  9. Perform the Diagnostic System Check - Vehicle .
  10. Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the secondary circuit of the brake modulator assembly, which may have been introduced into the primary circuit.

    If the pedal feels spongy, perform the Antilock Brake System Automated Bleed Procedure .

scientia non olet · About LEMON Manuals