Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: EBCM

Courtesy of GENERAL MOTORS CORP.

Position the EBCM (1) to the BPMV.
Push the EBCM squarely onto the BPMV.

Fig 2: EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the EBCM bolts (1).
Tighten: Tighten the bolts in an X pattern to 3 N.m (27 lb in).
Connect the EBCM electrical connector.
If installing a new EBCM, the EBCM must be programmed and the sensor and boost valve calibration and EBCM learn processes must be performed. Refer to Control Module References .