LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1952 (Antilock Brake System - Hybrid 3.6L (Hp5)) >> Diagnostic Information and Procedures >> DTC C0552 or C121D >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the electronic brake control module.
  2. Ignition OFF, test for less than 1 ohm between the ground circuits listed below and ground.
    • Terminal 13
    • Terminal 38
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit Terminal 1 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Cycle ignition, verify DTC C0552 or C121D is not set.
    • If DTCs are set, replace the EBCM.