LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1951 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the park brake lever in the fully released position.
  2. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  3. Remove the front floor console. Refer to Front Floor Console Replacement .
    4. Fig 1: Park Brake Cable Adjustment Nut
    GM1876517Courtesy of GENERAL MOTORS CORP.
  4. Using ONLY hand tools, loosen the adjusting nut (1) completely to the end of the front cable threaded rod.
    5. Fig 2: Rear Park Brake Cables
    GM1876518Courtesy of GENERAL MOTORS CORP.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Disconnect the left rear park brake cable (1) or the right rear park brake cable (2) from the front park brake cable equalizer.
    8. Fig 3: Park Brake Cable Bracket Bolt
    GM1876522Courtesy of GENERAL MOTORS CORP.
  8. Remove the park brake cable bracket bolt (1).
    9. Fig 4: Park Brake Cable Bracket Bolt And Nut
    GM1876523Courtesy of GENERAL MOTORS CORP.
  9. Remove the park brake cable bracket bolt (1) and nut (2).
    10. Fig 5: Park Brake Cable Eyelet
    GM1876525Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the park brake cable eyelet (1) from the park brake actuator.
  11. Compress the park brake cable conduit spring.
  12. Using the J 37043  , remove the park brake cable (2) from the mounting bracket. See Special Tools .
  13. Remove the park brake cable.
scientia non olet · About LEMON Manuals