LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1951 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Warning Lamp Switch
    GM1876521Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake warning lamp switch (1).

    Ensure the switch is properly positioned and the locking tabs are fully deployed.

    2. Fig 2: Park Brake Warning Lamp Switch Electrical Connector
    GM1876516Courtesy of GENERAL MOTORS CORP.
  2. Connect the park brake warning lamp switch electrical connector (1).
  3. Install the front floor console. Refer to Front Floor Console Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals