LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1951 (Parking Brake System) >> Repair Instructions >> Parking Brake Adjustment >> Park Brake Cable Adjustment

Park Brake Cable Adjustment

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable Adjustment Nut
    GM1876517Courtesy of GENERAL MOTORS CORP.
  1. Remove the front floor console. Refer to Front Floor Console Replacement .
  2. With the park brake lever in the fully released position, using ONLY hand tools, loosen the adjusting nut (1) completely to the end of the front cable threaded rod.
  3. Raise the park brake lever 1 detent position.
    4. CAUTION: Refer to Fastener Caution .
  4. Using ONLY hand tools, tighten the park brake cable adjusting nut until light to moderate drag is exhibited while rotating the rear wheels.
  5. Attempt to rotate the rear wheels. There should be no rotation forward or rearward.
  6. Fully release the park brake lever.
  7. Verify the park brake is released by rotating the rear wheels. The wheels should rotate freely and exhibit no park brake shoe drag.
  8. If the wheels do not rotate freely, repeat the park brake cable adjustment procedure.
  9. Raise the park brake lever 3 detent positions and attempt to rotate the rear wheels:
    • One of the wheels should not rotate forward or rearward.
    • The other wheel should not rotate forward or rearward, or should require substantial effort to rotate.
  10. Install the front floor console. Refer to Front Floor Console Replacement .
  11. Release the park brake lever.
scientia non olet · About LEMON Manuals