TFP Manual Valve Position Switch: Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing the TFP switch handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
- Carefully install the fluid pressure manual valve position switch (395). See Figure .
- Install the control valve body bolts (375, 379 and 381) that mount the fluid pressure manual valve position switch to the control valve body (300).
- Tighten the control valve body bolt (375) to 106 INCH lbs. (12 N.m), control valve body bolt (379) to 106 INCH lbs. (12 N.m) and control valve body bolt (381) to 70 INCH lbs. (8 N.m).
- Connect the transaxle wiring harness.
- Install the case side cover. See CASE SIDE COVER .