LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Automatic Transmission Servicing) >> Removal & Installation >> Output Shaft >> Installation

Output Shaft: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive axle retainer rings (509) to the output shaft (510). See Figure and Figure .
  2. Hold the front differential carrier in place and carefully install the output shaft (510) to the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  3. Install the case extension housing. See CASE EXTENSION HOUSING  .
  4. Install the left drive axle to the transaxle. See appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
scientia non olet · About LEMON Manuals