LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1947 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. NOTE: In the following service procedure, it is not necessary to remove the rear suspension support. Lower the support enough to remove the stabilizer bar.
  2. Lower the rear suspension support. Refer to Support Replacement .
    3. Fig 1: View Of Stabilizer Link-To-Stabilizer Shaft Nut
    GM1828864Courtesy of GENERAL MOTORS CORP.
    NOTE: Hold the ball shaft secure with a 90° bend style TORX® bit, when removing the nut.
  3. Remove the stabilizer link to stabilizer shaft nut.
    4. Fig 2: View Of Stabilizer Bar Clamp & Bolts
    GM1828862Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer shaft clamp bolts.
  5. Remove the stabilizer shaft clamps and bushings from the stabilizer shaft.
  6. Disengage the stabilizer shaft from the stabilizer link ball studs, while removing the stabilizer shaft from the vehicle.
scientia non olet · About LEMON Manuals