LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1947 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the stabilizer shaft in the vehicle, while positioning the links to the stabilizer bar.
  2. Install the stabilizer shaft clamps and bushings to the stabilizer shaft.
    3. Fig 1: View Of Stabilizer Bar Clamp & Bolts
    GM1828862Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the stabilizer shaft clamp bolts and tighten to 70 N.m (52 lb ft).
    4. Fig 2: View Of Stabilizer Link-To-Stabilizer Shaft Nut
    GM1828864Courtesy of GENERAL MOTORS CORP.
    NOTE: Hold the ball shaft secure with a TORX® bit, when installing the nut.
  4. Install the stabilizer link to stabilizer shaft nut and tighten to 50 N.m (37 lb ft).
  5. Install the rear suspension support. Refer to Support Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals