LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1947 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement .
  4. Position a jackstand underneath the lower control arm.
  5. Raise the jackstand slightly to compress the coil spring.
    6. Fig 1: Identifying Lower Shock Bolt & Nut
    GM1828810Courtesy of GENERAL MOTORS CORP.
  6. Remove the lower shock bolt and nut.
    7. Fig 2: Locating Lower Control Arm-To-Support Frame Nut & Bolt
    GM1829052Courtesy of GENERAL MOTORS CORP.
  7. Loosen the lower control arm to support frame nut and bolt.
    8. Fig 3: View Of Lower Control Arm-To-Knuckle Nut & Bolt
    GM1829056Courtesy of GENERAL MOTORS CORP.
  8. Remove the lower control arm to knuckle nut and bolt.
  9. Slowly lower the control arm in order to unload the coil spring.
  10. Remove the coil spring.
  11. Remove the jackstand.
    12. Fig 4: Identifying Lower Control Arm-To-Support Frame Nut & Bolt
    GM1829093Courtesy of GENERAL MOTORS CORP.
  12. Remove the lower control arm to support frame nut and bolt.
  13. Remove the lower control arm.
scientia non olet · About LEMON Manuals