LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1941 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Brake Pipe Fitting
    GM1874795Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the brake pipe fitting (1) from the brake hose.

    Cap the brake pipe fitting to prevent brake fluid loss and contamination.

    4. Fig 2: Brake Hose Bolt
    GM1874796Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake hose bolt (1) securing the brake hose bracket to the wheelhouse.
    5. Fig 3: Brake Hose Bracket Bolt
    GM1874799Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake hose bracket bolt (1).
    6. Fig 4: Brake Hose Fitting Gaskets
    GM1874802Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake hose fitting bolt (1) from the brake hose and the caliper.
  7. Remove the brake hose (2) from the caliper.
    8. NOTE: Do not reuse the brake hose fitting gaskets.
  8. Remove and discard the brake hose fitting gaskets (3).
  9. Remove the brake hose.
scientia non olet · About LEMON Manuals