LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1941 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement (With RPO HP5) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
  2. Remove the accelerator pedal position sensor. Refer to Accelerator Pedal Position Sensor Replacement .
  3. Remove the stop lamp switch. Refer to Stop Lamp Switch Replacement .
    4. Fig 1: Brake Booster Pushrod Retainer Nut
    GM2193343Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake booster pushrod retainer nut (1).
  5. Disconnect the brake booster pushrod from the brake pedal pivot pin.
    6. Fig 2: Brake Pedal Bracket Bolt
    GM1874784Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pedal bracket bolt (1).
  7. Remove the instrument panel tie bar. Refer to Instrument Panel Tie Bar Replacement .
    8. Fig 3: Brake Pedal Bracket Nuts
    GM2193344Courtesy of GENERAL MOTORS CORP.
  8. Remove the brake pedal bracket nuts (1) and the brake pedal assembly.
scientia non olet · About LEMON Manuals