Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Brake Fluid Level Sensor

Courtesy of GENERAL MOTORS CORP.

While noting the proper orientation, install the brake fluid level sensor to the master cylinder.
Press the brake fluid level sensor firmly into the master cylinder reservoir, ensuring that the retaining tabs are fully engaged.

Fig 2: Disconnecting/Connecting Brake Fluid Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the brake fluid level sensor electrical connector.
Install the radiator surge tank. Refer to Radiator Surge Tank Replacement .