Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake delay valve.
- Install the 2 brake delay valve bolts (1).
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Connect the secondary brake pipe outlet fitting (1) at the brake delay valve.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Tighten the secondary brake pipe fitting at the BPMV.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Connect the primary brake pipe outlet fitting (1) at the brake delay valve.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Tighten the primary brake pipe fitting at the BPMV.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Connect the secondary brake pipe inlet fitting (1) at the brake delay valve.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Tighten the secondary brake pipe fitting at the master cylinder.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Connect the primary brake pipe outlet fitting (1) at the brake delay valve.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Tighten the primary brake pipe fitting at the master cylinder pressure sensor mounting block.
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
- Connect the brake delay valve electrical connector (1).
- Install the radiator surge tank. Refer to Radiator Surge Tank Replacement .
- Install the 12V battery. Refer to Battery Replacement .
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
CAUTION:
Refer to Fastener Caution
.