LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Heater Systems) >> Removal & Installation >> RECIRCULATION Door >> Removal

RECIRCULATION Door: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant from the A/C system (if equipped). See RECOVERY, EVACUATING & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING. Remove the coolant recovery reservoir or the surge tank. Remove the battery from vehicle.
  2. Disconnect the electrical connectors. Remove the accumulator (if equipped). Remove the evaporator tube from the evaporator. Remove the screws from the evaporator front cover.
  3. Remove the evaporator front cover. Separate the case halves. Remove the recirculation door actuator and the linkage. Remove the recirculation door from the evaporator case. See Fig 1.
Fig 1: Removing & Installing Recirculation Door
G00067666Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals