LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Heater Systems) >> Removal & Installation >> Auxiliary Blower Motor Resistor >> Installation

Auxiliary Blower Motor Resistor: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the blower motor resistor to the blower case. See Fig 1. Install the retaining screws. Connect the electrical connector to the blower motor resistor. Install the left rear quarter trim panels.

Fig 1: Removing & Installing Auxiliary Blower Resistor
G00185015Courtesy of GENERAL MOTORS CORP.